KIT DE CONVERSION A ENCENDIDO ELECTRONICO MARCA PERTRONIX IGNITOR 2 #91281APLICA PARA FORD, LINCOLN , MERCURY V8MODELOS DE 1957 A 1975MOTORES V8CON ESTE KIT CONVIERTES TU DISTRIBUIDOR DE PLATINO-CONDENSADOR EN ELECTRONICODATOS DEL FABRICANTE:Conversion Kit Trigger Style: Hall effectGround: NegativeAdvance Type: Vacuum and mechanicalRev Limiter: NoVolts: 12 VQuantity: Sold as a kit.Notes: Fits Motorcraft single point distributors. Not for use with solid core spark plug wires.Not ones to leave well enough alone, the people at PerTronix set out to better their highly successful Ignitor® ignition conversion systems. The Ignitor II® conversion systems have all of the same quality features as the original Ignitor®, plus a powerful microprocessor controller to deliver, on average, four times more available energy between 3,000 and 5,000 rpm than standard ignition systems. They're an ideal choice for collector car restoration because they fit entirely under the distributor cap.Features include:* Compatible with 12 V negative ground systems and any induction coil* High-rpm performance is improved when used with the PerTronix Flame-Thrower II super low- resistance (0.6 ohms) 45,000 V coil* Adaptive dwell maintains peak energy throughout the entire rpm range, reducing misfires while improving engine performance* Develops, on average, two times more available plug voltage* Peak current level is reached just prior to spark for maximum energy without heat build-up, increasing coil and module life* Never change points again* Adjusts spark timing at higher rpm to compensate for the inherent electronic delay* Senses startup and develops more energy for quicker, easier starting* Built-in reverse polarity and over current protection shuts down the system, preventing component damage* Cannot be used with solid core spark plug wires—suppression-style or spiral-wound spark plug wires must be used